Summer can also be said that the rainy season, when using wipers to ensure the smooth position of the road is a very common and common thing, during the usual glass interface cleaning, how to remove the wiper is worthy of our special attention and understanding Take a look and help to achieve satisfactory results with the wiper effect.

From the current point of view, how to remove the wiper, or need to make a better attempt according to the actual needs of different wipers during use, is to ensure that the use of effects to achieve a better and effective presentation. In general, an ordinary type of wiper, by turning off the flame after reset, manually takes the wiper up while the vehicle is stopped, and then takes out the wiper in a reversed direction. The wiper method is also a skill to disassemble the wiper.

In addition, there is a common type of wiper on the market that can't be returned after reset. What the handsome and handsome need is to start the wiper under the condition that the car is on fire, and when it is seen that the position of the wiper stays on In the middle, turn off the flames. In this way, the current state of the wiper is maintained in the upright state. In order to ensure that the wiper can be smoothly removed, the owner should be able to prepare a soft towel in the position of the windshield, according to the current scraping. The specific position and angle of the sheet, using a towel as a support point, to support it, and then disassemble and install it, will often save some time during the demolition. At the same time, after the position of the wiper is adjusted to 90 degrees, it is the best disassembly angle. By swinging the arm, the clip can be loosened and the wiper can be easily removed.

How to remove the wiper After the friends have mastered these details of the operation methods and steps, in the use of the future can be a simple understanding of the use of this to better choose the application, so that the wind effect of glass to meet people's satisfaction standard.

Bitumen Gear Pump beed used to transfer high temperature bitumen, pump with heat insulation jacket. pump can bear 350 degree high temperature.  the heat insulation jacket could be used in heating, cooling and keeping heat for liquid and pump when circulate the heat-conducting oil, steam and hot water. bitumen's viscosity is 1-1500 cst, this pump have large flow rate and high pressure. Cost-effective compared to other pumps. Used in asphalt mixing plants and road and bridge industries.

Bitumen Gear Pump

Bitumen Gear Pump,Asphalt Emulsion Gear Pump,Bitumen Transfer Gear Pump,Electric Bitumen Gear Pump

Botou Honghai Pump Co.,Ltd , http://www.pumphonghai.com