Brass has excellent CNC Machining Turning performance, high-speed machining turning under the brass can get excellent surface finish. Our technical team has very good experience in machining brass, machining brass including brass plate, brass rod, brass tube. Brass hardware parts has high strength, good plasticity in hot state, good plasticity in cold state, good machinability, easy welding and good corrosion resistance. Brass parts are very durable. It is electrically conductive and does not usually corrode or deteriorate over time. Thus brass is often used to produce products with longer service life. Machining brass parts Widely used: pipes, radiators, ship parts.
Machining Brass, Brass Machined Parts, Perfessional Brass Parts Machining, Machining Brass Conponents, Brass Parts Machining Hong Kong RYH CO., LTD , https://www.szcncturning.com
The inland low-speed wind power project was invested by China Guodian Longyuan Group Co., Ltd. with a total investment of approximately 3.5 billion yuan. The total installed capacity is 350,000 kilowatts, and the annual on-grid electricity consumption is approximately 700 million kwh. The 49,500 kilowatts of the first-phase project will be completed in 2012 and completed on-grid power generation. After 33 wind turbines have been built, the country can save 214,000 tons of standard coal annually and reduce the emission of 467,000 tons of greenhouse gas CO2. It can save 2.03 million cubic meters of water, and reduce the corresponding waste water discharge and warm water drainage. It is understood that the project was identified as one of the 200 key projects in the province in 2012.
The first inland low-speed wind turbine in Jiangsu province settled down
Recently, the first inland low-speed wind turbine in Jiangsu province was successfully hoisted in Yuhuangshan, Heqiao Town, Yuxian County. This is an important achievement of the development of clean energy in Jiangsu Province and the implementation of an environmental protection economy.